A word of warning for you 500 owners out there. The washers jets on the 500 are of a comically bad design. Basically you have the body of the washer jet and then the nozzle is a little plastic cylinder which slots in the side with an opening for the water to come in and then 3 holes for the water to go out and spray onto your windscreen.
Well it seems that when you get a bit of ice on the car and the washer fluid freezes up it then pushes the little cylinder out the side of the washer jet body and no matter how much you push it back in it just comes back out when you squirt the washers
Well it's going to have to go into the garage to get this sorted under warranty but you could prevent this from happening by not being a retard like me and having the proper concentration of washer fluid in the bottle so it doesn't freeze up
For anyone who doesn't know how much to use it's on the bottle.
Same design on the Panda and same problems. I can see the forum being full of this when the weather starts to cool down properly
https://www.fiatforum.com/panda/126641-100hp-screen-washer-jets-rubbish.html
I hope you enjoyed your 5 minutes of Bill O'Reilly as well
I was out there for a good 30 minutes before trying to adjust the washers and make them stay in but the ****in' thing does appear to suck and they just won't stay in.
Well it seems that when you get a bit of ice on the car and the washer fluid freezes up it then pushes the little cylinder out the side of the washer jet body and no matter how much you push it back in it just comes back out when you squirt the washers
Same design on the Panda and same problems. I can see the forum being full of this when the weather starts to cool down properly
https://www.fiatforum.com/panda/126641-100hp-screen-washer-jets-rubbish.html
I hope you enjoyed your 5 minutes of Bill O'Reilly as well
Last edited by a moderator: