Technical Flashing odometer and no BlueMe or usb

[kawasakikz1]

Just picked up my mother's 2016 panda. It had a new battery last week. The BlueMe USB are dead and the odometer meter is flashing. I've refitted the battery to no effect. Any suggestions would be helpful. Many thanks

 

[varesecrazy]

Just picked up my mother's 2016 panda. It had a new battery last week. The BlueMe USB are dead and the odometer meter is flashing. I've refitted the battery to no effect. Any suggestions would be helpful. Many thanks

Hi

Flashing is because "network is incomplete"

Unplug the B+M and then reset the system

Flat battery is common with failure of B+M

 

[A3jeroen]

Blue & Me unit broken? Repair or disconnect.
Proxy allignment with MES.

gr J

 

[bun]

As mentioned try the battery first, but blue and me is very sensitive to voltage spikes so it maybe dead and need repaired.

 

[kawasakikz1]

Okay thanks. For help

 

[Panda IIs]

Okay thanks. For help

Blue and me (B&M) module almost certainly dead. Module is under the (RHD) driver's seat - it needs to be unplugged here since it tends to fail "on" leaving a parasitic drain on the battery when parked (flat battery within a week if car not used).

Use the search function on here to find many threads that detail issues and the various repair solutions. Flashing odometer is signal that CanBus system cannot detect a module it was expecting.

My experience is that you can fit a second hand unit without reprogramming (mine was swapped with an Alfa unit that doesn't fit the bracket under the seat but does the job). Other's experience suggests that if you refurb then you do need to reprogramme the body control module since the new unit will not have an "address".

 

[Jamaludin sikin]

As mentioned try the battery first, but blue and me is very sensitive to voltage spikes so it maybe dead and need repaired.

Sir, what do you mean try the battery can u please elaborate,

 

[bun]

Sir, what do you mean try the battery can u please elaborate,

Disconnect the battery for 30 minutes to allow the system to reset. If it still doesn't work the blue and me is dead and needs repaired/ replaced or removed.

 

[Jamaludin sikin]

Ok many Thank sir, very help full

 

[Jamaludin sikin]

Disconnect the battery for 30 minutes to allow the system to reset. If it still doesn't work the blue and me is dead and needs repaired/ replaced or removed.

i just already doing disconectting the batery around 1 hour, and plugin in buat still flashing,
can u give advice what shoul i do next sir?

 

[varesecrazy]

i just already doing disconectting the batery around 1 hour, and plugin in buat still flashing,
can u give advice what shoul i do next sir?

Hello,

That BASIC RESET, obviously was not enough

You need to unplug the B+M(as it is the root of your problem)

Then do a System reset

You need Software for that

 

[Jamaludin sikin]

Hello,

That BASIC RESET, obviously was not enough

You need to unplug the B+M(as it is the root of your problem)

Then do a System reset

You need Software for that

It'is mean i can't doit by my self sir?

the worst think is fiat has no authorize service center in my country (Indonesia)

 

[varesecrazy]

It'is mean i can't doit by my self sir?

the worst think is fiat has no authorize service center in my country (Indonesia)

Look on the Web for

MultiECUScan

It is the software I use on my Fiat cars