Technical Torque for clutch and flywheel bolts 1.2 8V

[Elmo9]

I need to replace the rear crankshaft seal/gasket on my 2005 Mk2b 1.2 8V.
For that I need to remove the clutch and flywheel and would therefore like to know the torque of the bolts for these when re-installing.
I have found a some data for the flywheel saying 4.0-4.8 daNm (40-48 Nm) (new bolts) but I am unsure if this is correct.
For the clutch I have not found any torque data.

If anyone have these data please help.

 

[Ziggy122]

I need to replace the rear crankshaft seal/gasket on my 2005 Mk2b 1.2 8V.
For that I need to remove the clutch and flywheel and would therefore like to know the torque of the bolts for these when re-installing.
I have found a some data for the flywheel saying 4.0-4.8 daNm (40-48 Nm) (new bolts) but I am unsure if this is correct.
For the clutch I have not found any torque data.

If anyone have these data please help.

When i get chance ill look at what haynes manual says

I do think clutch bolts were quiet low like 19nm rings a bell
But the flywheel bolts id suspect itd be higher - nearer 100
But ill get haynes when i get home

Sent from my SM-G920F using FIAT Forum mobile app

 

[Elmo9]

I just talked to my local Fiat shop:
The flywheel bolts (M8) must be renewed and torqued to 4.0 - 4.8 daNm
The clutch bolts must be torqued to 1.2 - 1.5 daNm

I hope Haynes manual says the same ;-)