Hi All,
I'm busy restoring an Uno pacer 1.4 carburettor model 5 door with electric windows. It's been a bit of a challenge since the wiring harness has been hacked one too many times. I'm working at my own pace and deal with one issue at a time.
I'm struggling to figure out the wiring of the inlet manifold sensor and resistor heater see the attached image red highlighted circles. Then the vaccuum highlighted in yellow i managed to get a new one but not sure how to route this to the carb. Any tips or advice will be appreciated. Thanks in advance.
I'm busy restoring an Uno pacer 1.4 carburettor model 5 door with electric windows. It's been a bit of a challenge since the wiring harness has been hacked one too many times. I'm working at my own pace and deal with one issue at a time.
I'm struggling to figure out the wiring of the inlet manifold sensor and resistor heater see the attached image red highlighted circles. Then the vaccuum highlighted in yellow i managed to get a new one but not sure how to route this to the carb. Any tips or advice will be appreciated. Thanks in advance.
Attachments
Last edited: