New to all this.
Have Ducato that has had an intermittent problem for last two years (same fault each time). Main dealers cannot find it. The latest dealer (in Spain) says fault codes are not stored in ECU after the "Check Engine" warning and "Injection System Failure" light extinguish. (Is the really true? - Should they not be stored as "Intermittent" Errors in the ECU and then be visible with EXAMINER - forever or until the fault memory is cleared?)
So need to connect my laptop (Win7) and see for myself what the ECU says when the problem occurs. (Van might go 1000+km over several days with no faults, then it can occur a number of times over several days or weeks, before running perfectly OK again.)
Its a motorhome on a 2007 Ducato 130 Mulitjet chassis with K line diagnostic on the ECU (pin 25 on vehicle harness socket).
What cable do I need (the one listed early in thread is no longer available)? Where do I plug it in? (Is there socket somehwere under the dash?)
Where so I get the software? (The URLs for that and the instructions no longer work.)
Thanks - in desperation.