Interior
Fitting........
Interior,
Remove glovebox (by sliding peg to the right in glovebox,left hand side) and at the bulkhead where you will see the previously passed through wire.Pull this wire through and route this wire to the right towards the centre consul,remove the centre consul side trim by carefully pulling it at the rear of the trim (theres 3 retaing clips there) then moving it towards rear of car ,theres a plastic locating peg that goes into a bracket so remember to make sure this is in line when refitting.
You can refit glovebox & consul side trim now as there is no further need for these to be removed.Its a good idea to use a couple of cable ties to make sure the wire doesn't flap about or catch on anything.
Route wire as indicated by white line in the picture below...
Remove the gear lever surround by lifting up (gear leather trim is velcro fit) & unplug the cigarette lighter connector by pressing tag in & pulling downwards. Pull the cigarette lighter wires through the gear lever opening as far as possible.
Drill & posistion switch,I mount mine just to the left of the handbrake on the slope section as when the switch is operated the 'switch on' LED is clearly visable from the drivers posistion and its not obtrusive and looks factory fit.
Note,picture below for switch position is for left hand drive,red dot marks switch position.
Wire up the switches 3 terminals as follows,check termination on switch as may vary.but basically you have 'supply in','supply out' & 'earth' which is used to bring on the LED when the switch is in the on position.
1)Sidelight supply to switch...solder 6inch section of 14 gauge wire from cigarette lighter sidelight supply.This is ok to use as you are only using it to switch the relay contacts not directly power the foglights.
2)Earth...solder 6 inch section 14 gauge wire from cigarette earth.
You can of course use 'scotch lok' type connectors for the above if you find it easier.
3)Switch output the wire you have brought through the bulkhead from relay terminal 86 to the remaining terminal using spade connector.
Refit all removed trim/panels & turn on sidelights (ignition on) & flick the front fog switch & hey presto front fog lights.
- Previous page: Exterior
