Technical Wiring diagram

[gweath]

Hi My starter motor refused to work on two frosty mornings so I removed it and it worked fine on the bench.
The wire from the ignition switch to the selenoid has no power when key is turned.
I am wondering if a wire from the switch to the seleniod will do the job.
Any help will be very helpful.

 

[the green vanper]

Hello,

Just a thought: isn't it a problem with the immobilizer?

As far as I remember there's a eLearn CD image file available for the x244 in the download section of the forum. It should be helpful. Have you checked it?

 

[Communicator]

Sorry, most definitely not a problem with the immobiliser.
Could be the ignition switch, or wiring which routes via the engine bay fusebox.
Applicable Fiat eLearn diagram E5010 attached.
I have also attached colour code translation sheet, and a recent diagram of mine showing the ignition switch in a different way. In this latter diagram there is connection across the switch, where there is a black square associated with that switch position..

 

[gweath]

Thank you very much I will try the wire from the fusebox first.It's strange that both times it happened it was below freezing.

Sorry, most definitely not a problem with the immobiliser.
Could be the ignition switch, or wiring which routes via the engine bay fusebox.
Applicable Fiat eLearn diagram E5010 attached.
I have also attached colour code translation sheet, and a recent diagram of mine showing the ignition switch in a different way. In this latter diagram there is connection across the switch, where there is a black square associated with that switch position..