Technical torquing the head

[sam]

hi every one
verry happy to meet this forum
im in the process of replacing the hrad gasket and looking for the torquing figures of the head bolts
i also need the timing marks
p.s
it is advisable to replace the water pump at the same time even if it is in a good condition since you dont want to do the timing process again in a couple of months
by the way my fiayt blew its head (not the gasket) after 180000 k so im quite sattisfied

 

[dave]

The torquing for 8v single ohc 1242cc engine are stage one 30Nm or 22lbf ft. second stage angle tighten further 90 degreese third stage angle tighten a thurther 90 degrese (best to use an angle gauge) tightining orber is.
8625,10
73149.
Rember you must use new bolts.
Best if you give me an email address so i can send a picture of timing marks.