Technical semi-automatic gearbox, does robot need special learning

[Ybosch]

I've had problems since semi-automatic gearbox robot has been replaced, some strange creaking sounds (posted about it earlier). Since the 3rd complete reset of the semi-automatic gearboxrobot the strange sounds (crunchy sound like metal moving over metal, not screaking high pitch) there seems to be improvement.
Question; the garage's reset the robot and said it'll need to learn itself wilst driving. Is this enough, "just drive" or are there certain actions that need to be done straight after reset. If so, what actions?

Greetings, Ybosch

 

[the green vanper]

Hello,

As far as I remember, there are several steps to make whilst servicing the Dualogic / Selespeed / Comfortmatic / F1 robot.

Perhaps you'll find an answer here:

Home Page

aftersales.fiat.com

If you change the languageID in the address to 6 as far as I remember you should be able to get the text in Dutch but not sure about the translation quality

 

[MSjoberg]

If the complete reset you mentioned included the appropriate ones from the list below, that should be sufficient. After a major overhaul, end of line/service self-calibration is most important. Has this been executed?