1.2 Pop 2012
Starts runs and drives well but when hot, idles badly, Revs drop and rebound alternately gradually getting worse until it stalls. There are NO OBDII codes.
I have done the following:
New Airbox breather hoses
New Airbox to Throttle Body Seal
New Air Filter
New Spark Plugs
New Crank Sensor
New MAP Sensor
Throttle Body removed and Cleaned
Using MultiECUScan: I have reset throttle position sensor and Reset all learned codes
Additionally I have replaced the timing and aux belts using a full locking kit so the timing was not disturbed. The poor idle existed BEFORE the timing belt change anyway.
On YouTube a couple of years back, the Love500 channel guy had this exact same problem. He had had already replaced the inlet manifold, the throttle body, the knock sensor and the camshaft position sensor, none of which fixed the problem and it was only finally fixed by his MOT station resetting something on the ECU but sadly, he didn't say what exactly they reset.
Anybody got any ideas of what they might have done and can I do the same with MES?
Thanks in advance for any help.
Starts runs and drives well but when hot, idles badly, Revs drop and rebound alternately gradually getting worse until it stalls. There are NO OBDII codes.
I have done the following:
New Airbox breather hoses
New Airbox to Throttle Body Seal
New Air Filter
New Spark Plugs
New Crank Sensor
New MAP Sensor
Throttle Body removed and Cleaned
Using MultiECUScan: I have reset throttle position sensor and Reset all learned codes
Additionally I have replaced the timing and aux belts using a full locking kit so the timing was not disturbed. The poor idle existed BEFORE the timing belt change anyway.
On YouTube a couple of years back, the Love500 channel guy had this exact same problem. He had had already replaced the inlet manifold, the throttle body, the knock sensor and the camshaft position sensor, none of which fixed the problem and it was only finally fixed by his MOT station resetting something on the ECU but sadly, he didn't say what exactly they reset.
Anybody got any ideas of what they might have done and can I do the same with MES?
Thanks in advance for any help.
