Hey, Just wanted to know what they were made from? Rubber? Silicon?
GSR Induction?
- Thread starter bredsticz
- Start date
Currently reading:
GSR Induction?
very thin Silicon
whatever happened to Oldschool?
got banned wouldnt pay his traders fees but kept trading, and leaving forum staff to deal with all his complaints of kits not getting sent to people
Ahhh really?! Thats a shame, he seemed a friendly chap
people are not always what they seem
OP
OP
What traders fees :s they on here?
Just wondering how hard it'd be ro mould yourself and stick any ebay filter on the end
Just wondering how hard it'd be ro mould yourself and stick any ebay filter on the end
- Joined
- Apr 8, 2004
- Messages
- 25,218
- Points
- 3,672
Hard. The whole reason they work is that there's actual engineering behind the size and shape.
they start at less than £10 a month, thats very cheap compared to other forums of this size
OP
OP
I didn't know there were traders fees. Whats it for? As in selling bulk items etc?
Also I know the size and shape of them effects but if it was easy enough to mould the material then I could get measurements of one and replicate it
well a trader is on the forum to sell
if you want to use the forum as a revenue stream then you pay a little towards the forums costs
have you not seen theres a traders section?
OP
OP
OP
OP
Had just found it Never seen that before. Must have skipped past it everytime! That or I'm just blind.
Ao how hard would it be to mould?
Never seen that before. Must have skipped past it everytime! That or I'm just blind.Ao how hard would it be to mould?
you have to make tooling for it out of steel, then wrap sheets of silicone around it, then a special tape about 1cm wide has to be wrapped around that, then you have to back it all in a high tempatrure oven, then pick off all the holding tape whilst its still hot and remove the tooling from inside it
OP
OP
Would it not be possible to make a mould for it and pour the silicone in as a liquid before it's formed?
No but you can easily source the required parts to build your induction from Silicone yourself.
Whats it going on?
So far I've made a kit for the 1.9 GP Mjet, 1.3 GP Mjet and 1.4 16v.
Take a nosey at this thread
https://www.fiatforum.com/grande-pu...t-induction-kit.html?highlight=mjet+induction
PS As dave says up top verrrrry thin silicone. Interestinly last night looking at a GSR vs the hoes i buy you could squish the GSR pipework quite a lot.
Whats it going on?
So far I've made a kit for the 1.9 GP Mjet, 1.3 GP Mjet and 1.4 16v.
Take a nosey at this thread
https://www.fiatforum.com/grande-pu...t-induction-kit.html?highlight=mjet+induction
PS As dave says up top verrrrry thin silicone. Interestinly last night looking at a GSR vs the hoes i buy you could squish the GSR pipework quite a lot.
thin isn't always bad though, it depends how much into weight reduction you are
OP
OP
It's for a 1.2 8v punto. Just wanted to see if I could replicate the gsr
