General Door seal

[Steveetee55]

Hi I want to replace my door seal rubber it's starting to perish the ice over the last few days is starting to take its toll would any if you lads or ladesses, either know the part location on eper or know what size it is so cold buy a pattern part

 

[KPat]

Is this what you're looking for ? https://eper.fiatforum.com/en/Drawings/Detail/F/F/GIN/33/701/29/80/0/SubSubGroup

 

[Steveetee55]

Yup that's it cheers

 

[The Panda Nut]

In freezing weather wiping the door seals with a silicon lubricant of a rag or some paper towel will help prevent it sticking to the door with frost. Recommended to do this every winter before the ice. WD40 Silicon or something similar does the job

 

[the green vanper]

I'm using this one: the Sonax rubber seal protector:

Makes less mess in the cockpit than a spray.

 

[Steveetee55]

In freezing weather wiping the door seals with a silicon lubricant of a rag or some paper towel will help prevent it sticking nto the door with frost. Recommended to do this every winter before the ice. WD40 Silicon or something similar

I use a silicon on it but it's already on its way out so when this bloody snow and ice has done one i will replace it, the snow which was fun at 1st, and the car loves it but I don't everywhere I go seen range rovers and all manner of 4x4s stuck or struggling but this panda draws all the attention cos it's a little husky that takes snow in its stride not even been remotely stuck yet spose there's always a 1st time but not yet

 

[Eltezz]

My personal favourite, have been using it for the past 20 years -

Gummi Pflege

 

[The Panda Nut]

My personal favourite, have been using it for the past 20 years -

View attachment 458227

Gummi Pflege

That sounds dirty! Its interesting to see the products you all use. I may try something differetn. Its usually whatever there is on the shelf for me.