Technical Tyre pressure display

[Jo M]

Hello all
Hoping someone can help! I have a Fiat 500 X -2015. I've owned it just under a week. Everything is fine apart from the tyre pressure display on the main screen (where it should normally have the MPH displayed) The tyres are all fine and at the correct pressure and there are no warning lights on. I can't get rid of this tyre pressure display screen!! I've reset and pressed OK about a zillion times and scoured the handbook to no avail. Can anyone help?
Thanks in advance

 

[DGPunto]

If I remember right you need the ignition on but the engine off, then press and hold the OK until the reset is complete. Then turn the ignition off, open the door to turn off the system. Then you should be OK to restart the car. and the display should have reset

I do hope my memory is working OK!

 

[Jo M]

If I remember right you need the ignition on but the engine off, then press and hold the OK until the reset is complete. Then turn the ignition off, open the door to turn off the system. Then you should be OK to restart the car. and the display should have reset

I do hope my memory is working OK!

This may sound stupid- how would I do that? It's a button to start - and before you start the engine no displays are visible

 

[DGPunto]

On mine you jusr press the button once without your foot on the brake, Puts the ignition into the ACC position

 

[Jo M]

On mine you jusr press the button once without your foot on the brake, Puts the ignition into the ACC position

Fab - thanks

 

[varesecrazy]

Fab - thanks

Do let us know what you discover

 

[DGPunto]

Found it in the user manual under iTPMS:

To carry out the RESET procedure, with
the vehicle stopped and the ignition
device at MAR, use the Main Menu as
follows:
❒ go to "Vehicle info" and then to
"Reset tyre pressure"
❒ press the "OK" and hold down (more
than 2 seconds)
❒ the display will show the procedure
progress (with a graphic bar) till the
RESET is completed.
At the end of the RESET procedure the
display will show the "Reset saved"
message, indicating that the selflearning
has been started and you will
hear a beep. If the self-learning
procedure of the iTPMS system has not
been carried out correctly, you will not
hear the beep.

 

[DGPunto]

For reference if you don't have a copy to hand. Page 80 in here:

https://aftersales.fiat.com/eLumData/EN/00/334_500X/00_334_500X_603.99.791_EN_02_08.16_L_LG/00_334_500X_603.99.791_EN_02_08.16_L_LG.pdf

 

[Jo M]

Thanks ever so much - this is what I've done loads of times. It bleeps and says 'reset saved' but doesn't ever disappear

 

[DGPunto]

You must do it without the engine running or it doesn't work then switch off fully afterwards

 

[s130]

Another point to remeber is that when you have new tytes fitted or you rotate them then
1) Check all the pressures are correct
2) Reset the TPMS

Whenever I've had tyres replaced and have not rest the TPMS then after a while I/you will get the TPMS warning message.

 

[porta]

You can also swap between screens on the steering wheel controls
Just play with it until you get yourself familiar with it

 

[Jo M]

Thanks you lovely lot! All sorted xx